LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2017 >> G90 5.0 Ultimate, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Supplemental Restraint System Control Module & Sensors) >> Front Impact Sensor (FIS) >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2017 Genesis G80. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
  1. Install a new front impact sensor.
  2. Tighten the front impact sensor mounting nut.

    Tightening torque: 

    8.0 ~ 10.0 N.m (0.82 ~ 1.02 kgf.m, 5.9 ~ 7.4 lb-ft)

  3. Connect the front impact sensor connector.
  4. Install the radiator assembly.
  5. Reconnect the battery negative cable.
  6. After installing the front impact sensor, confirm proper system operation:

Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off.

scientia non olet · About LEMON Manuals