Front Side Airbag
WARNING: This page is about a different car, the 2017 Genesis G80. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Be sure to install the harness wires so they will not pinch or interfere with other parts.
NOTE:
- Do not open the lid of the side airbag cover.
- Make sure that the airbag assembly cover is installed properly. Improper installation may prevent a proper deployment.
- Disconnect the battery negative cable and wait for at least three minutes.
- Place a side airbag on the side airbag frame and tighten the side airbag mounting nuts (2 EA)
Tightening torque:
6.8 ~ 8.8 N.m (0.7 ~ 0.9 kgf.m, 5.1 ~ 6.5 lb-ft)
- Install a new seat back cover.
(Refer to Body - "FRONT SEAT BACK COVER ")
- Install the front seat assembly, and then connect the side airbag harness connector.
- Recline and slide the front seat forward fully, make sure the harness wires are not pinched or interfered by other parts.
- Reconnect the battery negative cable.
- After installing the side airbag (SAB), confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off.
- Install a new front seat assembly.
(Refer to Body - "FRONT SEAT ASSEMBLY ")