Description and Operation: Description

Steering Wheel Angle Sensor detects rotating direction of the vehicle. The rotating direction detected by the sensor is sent to the HECU as CAN signal via CAN communication.

HECU detects speed of the steering wheel handling and the angle with this CAN signal. HECU also uses this signal as the input signal to control anti-roll.

1. Disconnect the negative cable from the battery and wait for at least 30 seconds.
2. Turn the steering wheel so that the front wheels are aligned in a straight line.
3. Remove the DAB module.

   (Refer to AIRBAG MODULE Restraint )

4. Disconnect the connector & lock bolt (A) and then remove the steering wheel by using special service tools (09561-11001).

   Tightening Torques: 

   39.2 ~ 49.0N.m (4.0 ~ 5.0 kgf.m, 28.9 ~ 36.2lb-ft)

   Information 

   Tighten the lock bolt appropriately and install the SST (09561-1101) in order to remove the steering wheel easily.

   NOTE: Do not hammer on the steering wheel to remove it; it may damage the steering column.
   When installing, do not reuse the steering lock bolt.
5. Remove the steering column shroud.

   (Refer to STEERING COLUMN SHROUD LOWER PANEL Body )

6. Remove the clock spring.

   Courtesy of

7. Install in the reverse order of removal.