LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2024 >> Sierra 2500 HD Denali Ultimate >> Repair and Diagnosis >> Suspension >> Suspension Control Systems >> Suspension Controls >> Repair Instructions >> Ride Control Switch Replacement >> Removal Procedure

Removal Procedure

  1. GM5000730Courtesy of GENERAL MOTORS COMPANY

    Using a flat-bladed plastic trim tool, release the retaining clips.

  2. Start at the back and work your way inboard to release the tabs.
  3. Instrument Panel Fuse Block Access Hole Cover (1) - Remove
  4. GM5000816Courtesy of GENERAL MOTORS COMPANY

    Instrument Panel Trim Pad Bolt (1) - Remove [2x]

  5. Instrument Panel Trim Pad (2) - Remove
  6. Disconnect all electrical connectors.
  7. GM5630539Courtesy of GENERAL MOTORS COMPANY

    Release the retaining tabs.

  8. Ride Control Switch (1) - Remove


  1. GM5900953Courtesy of GENERAL MOTORS COMPANY
    WARNING:

    When removing, handling or installing this component wear protective gloves. The sharp edges on the component may be very sharp and may cause injury.

    NOTE:

    Use a plastic trim tool if necessary.

    Instrument Panel Knee Bolster (1) - Remove

  2. Using a flat-bladed plastic trim tool, release the retaining clips.
  3. Pull away from the front side door weatherstrip to remove the instrument panel outer trim cover (2).
  4. GM5903580Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Loosen just enough of the component to access the fastener.

    Instrument Panel Cluster Trim Plate (1) - Loosen

  5. Instrument Panel Switch Trim Plate Bolt (2) - Remove [3x]
  6. GM5903583Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Use a plastic trim tool if necessary.

    Reposition the component to access the electrical connectors.

  7. Disconnect the electrical connectors.
  8. Instrument Panel Switch Trim Plate (1) - Remove
  9. GM5902245Courtesy of GENERAL MOTORS COMPANY

    Release the retaining tabs.

  10. Ride Control Switch (1) - Remove


  1. GM5900953Courtesy of GENERAL MOTORS COMPANY
    WARNING:

    When removing, handling or installing this component wear protective gloves. The sharp edges on the component may be very sharp and may cause injury.

    NOTE:

    Use a plastic trim tool if necessary.

    Instrument Panel Knee Bolster (1) - Remove

  2. Using a flat-bladed plastic trim tool, release the retaining clips.
  3. Pull away from the front side door weatherstrip to remove the instrument panel outer trim cover (2).
  4. GM5912970Courtesy of GENERAL MOTORS COMPANY

    Instrument Panel Switch Trim Plate Bolt (1) - Remove [2x]

  5. GM5903583Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Use a plastic trim tool if necessary.

    Reposition the component to access the electrical connectors.

  6. Disconnect the electrical connectors.
  7. Instrument Panel Switch Trim Plate (1) - Remove
  8. GM5902245Courtesy of GENERAL MOTORS COMPANY

    Release the retaining tabs.

  9. Ride Control Switch (1) - Remove
scientia non olet · About LEMON Manuals