Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Rear Closure Fixed Handle Applique (1) - Install

CAUTION:

Rear Closure Center Applique Bolt (2) - Install and tighten [6x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

The pickup box endgate molding (1) and the surface should be 21°C (70°F) prior to installation. The vehicle should remain at 21°C (70°F) for one hour after assembly to allow adhesive to develop sufficient bond strength.
When removing protective liners from the adhesive tape, be careful not to touch tape with hands and do not allow tape to come in contact with dirt or any foreign matter prior to adhesion.
Pickup Box Endgate Molding (1) - Install
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Some components not shown for graphic clarity.

Pickup Box Endgate Inner Panel Access Hole Plug (1) - Install [4x]
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Pickup Box Auxiliary Endgate Step (2) - Install
Pickup Box Auxiliary Endgate Hinge Bolt - Left Side and Right Side (1) - Install and tighten - [4x] Fastener Specifications
Close the pickup box auxiliary endgate step.