Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Position a NEW steering gear boot clamp (1) on the steering gear boot (2).

Courtesy of GENERAL MOTORS COMPANY

Steering Gear Boot Clamp (1) - Tighten- use CH-22610  Keystone Clamp Pliers (2)

Courtesy of GENERAL MOTORS COMPANY

Steering Gear Boot Outer Clamp (1) - Install

Courtesy of GENERAL MOTORS COMPANY

Install the steering linkage inner tie rod nut (1) until aligned with the previously placed matched mark on the steering linkage inner tie rod.

Courtesy of GENERAL MOTORS COMPANY

If reusing the steering linkage outer tie rod (1), add a small amount of grease on the lip of the rubber boot seal to prevent twisting or deforming of the boot. Do NOT apply grease to the ball joint stud. Adhesives, Fluids, Lubricants, and Sealers

Courtesy of GENERAL MOTORS COMPANY

Steering Linkage Outer Tie Rod Nut (1) - Install and tighten - Fastener Specifications

Courtesy of GENERAL MOTORS COMPANY

Tighten the steering linkage inner tie rod nut (1) during the front toe adjustment procedure.

Courtesy of GENERAL MOTORS COMPANY

{without NZZ} Install the steering gear skid shield:

1. Steering Gear Skid Shield (2) - Install
2. Steering Gear Skid Shield Bolt (1) - Install and tighten [2x] - Fastener Specifications

Courtesy of GENERAL MOTORS COMPANY

{with NZZ} Install the underbody skid shield:

1. Underbody Skid Shield (2) - Install
2. Underbody Skid Shield Bolt (1) - Install and tighten [2x] - Fastener Specifications

Courtesy of GENERAL MOTORS COMPANY

Underbody Splash Shield (2) - Install - Underbody Splash Shield Replacement (SLT)Underbody Splash Shield Replacement (Denali)Underbody Splash Shield Replacement (AT4X)Underbody Splash Shield Replacement

Courtesy of GENERAL MOTORS COMPANY

{If equipped} Retainer Clip (1) - Install