Removal Procedure
Using a flat-bladed plastic trim tool, release the retaining clips.
- Instrument Panel Outer Trim Cover (1) - Remove
Instrument Panel Fuse Block Access Hole Cover (1) - Remove
- Instrument Panel Knee Bolster Bolt (2) - Remove [ 2x]
Using a flat-bladed plastic trim tool, release the retaining clips.
- Reposition the component to access the electrical connectors.
- Disconnect the electrical connectors.
- Instrument Panel Knee Bolster (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Accessory Power Receptacle Switch (1) - Remove