Removal Procedure
- Turn vehicle power OFF and remove all keyless entry transmitters from the vehicle and secure in a place outside the vehicle.
- Drain the drive motor battery cooling system. Drive Motor Battery Cooling System Draining and Filling
- NOTE:
Left side shown, right side similar.
Front Bumper Fascia Bolt- Left Side and Right Side (1) - Remove [2x]
- Using a suitable plastic trim tool, release the retaining tabs.
- Front Bumper Fascia Skid Plate- Left Side and Right Side (2) - Reposition [2x]
Underbody Splash Shield Bolt- Upper (1) - Remove [6x]
- Underbody Splash Shield Bolt- Lower (2) - Remove [3x]
- Disconnect the electrical connector.
- Underbody Splash Shield (3) - Remove
- NOTE:
Some components not shown for graphic clarity.
Retainer (2) - Release
- Drive Motor Control Module Radiator Inlet Hose (1) @ Hybrid/EV Propulsion System Coolant Control Valve 1 - Remove
Radiator Inlet Hose Clip (2) @ Engine Cooler Fan - Remove
Retainer (2) - Release
- Drive Motor Control Module Radiator Inlet Hose (1) @ Engine Radiator - Remove
- Drive Motor Control Module Radiator Inlet Hose (1) - Remove