Component Testing

S45B Liftgate Control Switch - Interior-Static Test

1. Ignition/Vehicle - Off
2. Disconnect the electrical connector: S45B Liftgate Control Switch - Interior
3. Test for infinite resistance between the test points: Signal terminal 4 & Ground terminal 1 - Not Pressed
   • If less than infinite resistance 

     Replace the component: S45B Liftgate Control Switch - Interior

   • Go to next step: If infinite resistance 
4. Test for less than 3 Ω between the test points: Signal terminal 4 & Ground terminal 1 - Pressed
   • If 3 Ω or greater 

     Replace the component: S45B Liftgate Control Switch - Interior

   • Go to next step: If less than 3 Ω 
5. Test for 600 to 700 Ω between the test points: Signal terminal 3 & Ground terminal 1 - Switch S45B in position: Off
   • If not between 600 and 700 Ω 

     Replace the component: S45B Liftgate Control Switch - Interior

   • Go to next step: If between 600 and 700 Ω 
6. Test for 6000 to 6500 Ω between the test points: Signal terminal 3 & Ground terminal 1 - Switch S45B in position: 3/4
   • If not between 6000 and 6500 Ω 

     Replace the component: S45B Liftgate Control Switch - Interior

   • Go to next step: If between 6000 and 6500 Ω 
7. Test for 1900 to 2100 Ω between the test points: Signal terminal 3 & Ground terminal 1 - Switch S45B in position: Maximum
   • If not between 1900 and 2100 Ω 

     Replace the component: S45B Liftgate Control Switch - Interior

   • Go to next step: If between 1900 and 2100 Ω 
8. All OK.