Short Block: Remove & Replace

Consists of a Cylinder Block fitted with Pistons, Rings, Connecting Rods, Crankshaft, all Bearings and the following (where applicable): Camshaft(s), Timing Chain or Belt and Sprockets or Gears. Includes: Grind Valves, clean and transfer Cylinder Head(s), Fuel and Electrical Assemblies, Engine Mounts, Manifolds, Valve Cover(s), Oil Pan, Oil Pump, Timing Cover(s), Timing Components, Water Pump, Clutch Assembly and Flywheel. Adjust Valves.

Applies To	Note	Standard Hours	Skill Level
Gas,4WD	Includes: R&I Grille Assembly. Includes: R&I Grille Shutter. Includes: R&I Air Cleaner. Includes: R&I Fan Shroud Assembly. Includes: R&I Cooling Fan Assembly. Includes: R&I Cooling Module. Includes: R&I Alternator. Includes: R&I Water Pump. Includes: R&I Power Steering Pump. Includes: R&I Intake Manifold. Includes: R&I Front Propeller Shaft. Includes: R&I Starter Assembly. Includes: R&I Catalytic Converter. Includes: Drain and refill Cooling System. Includes: Bleed Power Steering System. Includes: Check and adjust Transmission Fluid level with fluid temperature within parameters. Includes: Reset Oil Life Monitor. DOES NOT include Air Conditioning System recover, evacuate and recharge.	29.8	A
Additional Procedure: SHORT BLOCK: Remove & Replace:
Where Skid Plate interferes add		0.2	A
Combination Procedure: CRANKSHAFT POSITION SENSOR: Reset:
Crankshaft Position Variation Learn	Includes: Additional time for use of scan tool to perform this procedure.	0.2	B
Combination Procedure: THROTTLE BODY ASSEMBLY: Reset:
Gas, Throttle Body Idle Air Flow Compensation Reset	Includes: Additional time for use of scan tool to perform this procedure.	0.2	B