Installation Procedure
- Steering Column (1) - Install
- Steering Column Nut (1) - Install and hand tighten [4x]
NOTE:
Support the steering column while installing the steering column nuts.
- Steering Column Nut (1) - Tighten in sequence [4x] 22 N.m (16 lb ft)
- Intermediate Steering Shaft (1) @ Steering Column - Install - Intermediate Steering Shaft Replacement
- Connect the steering column electrical connectors.
- Remove the device used to prevent steering column rotation.CAUTION:
The anti-rotation pin must be removed from the steering column before installing the steering wheel. Ensure that the steering wheel bolt is torqued to specification during steering wheel installation. Over torquing the steering wheel bolt can result in damage to the steering column rivets which will disable the telescoping mechanism. If the steering column rivets are damaged, a new steering column must be installed.
- Steering Wheel (2) - Install - Steering Wheel Replacement
- Floor Front Air Outlet Duct - Left Side (1) - Install - Floor Front Air Outlet Duct Replacement - Left Side
- Instrument Panel Knee Bolster (1) - Install - Instrument Panel Knee Bolster Replacement
- Steering Column Lower Trim Cover (1) - Install - Steering Column Lower Trim Cover Replacement (N37)
- Enable the SIR System. SIR Disabling and Enabling
- Center the steering angle sensor. Steering Wheel Angle Sensor Centering
- Perform functionality check of tilt and telescoping features.
CAUTION:
Refer to Fastener Caution .