Circuit/System Verification
- Ignition - On / Vehicle - In Service Mode
- Verify there are no DTCs set related to the following component/system: K43 Power Steering Control Module
- If any of the DTCs are set
- Go to next step: If none of the DTCs are set
- Perform the scan tool learn/reset function: Steering Wheel Angle Sensor Centering
- Verify that no DTCs are set.
- If any DTC is set
- Replace the component: Steering Gear
- Verify that no DTCs are set.
- If the DTC sets - Replace the component: K160 Brake System Control Module
- Go to next step: If the DTC is not set - All OK.
- Go to next step: If the DTC is not set
- All OK.