LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2020 >> Yukon SLE, RWD, Gas/Ethanol >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System >> Repair Instructions >> Front Wheel Speed Sensor Replacement (With 9C1) >> Installation Procedure

Installation Procedure

  1. Apply a light coat of wheel speed sensor anti-corrosion grease to the wheel speed sensor and mounting pad on the wheel hub and bearing assembly. Refer to Adhesives, Fluids, Lubricants, and Sealers .
  2. GM4205975Courtesy of GENERAL MOTORS COMPANY

    Wheel Speed Sensor (1) - Install

  3. GM4205949Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Fastener Caution

    Wheel Speed Sensor Bolt (1) - Install and tighten 13 N.m (115 lb in)

  4. Install the front wheel hub and bearing assembly to the steering knuckle while carefully feeding the wheel speed sensor harness through the brake shield.
  5. Install the front wheel hub and bearing bolts. Front Wheel Hub, Bearing, and Seal Replacement
  6. GM4205944Courtesy of GENERAL MOTORS COMPANY

    Wheel Speed Sensor Harness Clip (1) @ Steering Knuckle - Secure

  7. GM4205938Courtesy of GENERAL MOTORS COMPANY

    Wheel Speed Sensor Harness Clip (1) @ Brake Hose - Secure

  8. GM4205936Courtesy of GENERAL MOTORS COMPANY

    Wheel Speed Sensor Electrical Connector Clip (1) - Secure

  9. Wheel Speed Sensor Electrical Connector - Connect
  10. Front Brake Rotor Replacement (JD9, JB1) - Install
  11. Remove the tire and wheel assembly. Tire and Wheel Removal and Installation
  12. Perform the Diagnostic Repair Verification after completing the repair:Diagnostic Repair Verification
scientia non olet · About LEMON Manuals