Removal Procedure
WARNING: This page is about a different car, the 2019 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
WARNING:
- Set the parking brake in Service Mode.
- Install a scan tool.
- Turn the ignition ON with the engine OFF.
- Select Electronic Brake Control Module.
- Select Control Functions.
- Select Rear Brake Caliper Piston Retract.
NOTE:Do NOT apply any brake pressure during this step.
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Remove the tire and wheel assembly. Tire and Wheel Removal and Installation
- Disconnect the parking brake actuator electrical connector.
- Release the wiring harness from the parking brake actuator and position aside.
Brake Hose Fitting Bolt (1) - Remove
Brake Hose Fitting Gasket (1) @ Brake Hose Fitting (2) - Remove and DISCARD [2x]
- Cap the brake hose fitting to prevent brake fluid loss and contamination.
- NOTE:
Do NOT use any air tools to remove or install the rear brake caliper guide pin bolts. Use hand tools ONLY.
Rear Brake Caliper Guide Pin Bolt (1) - Remove [2x]
Rear Brake Caliper (1) - Remove
- Parking Brake Actuator - Remove - Parking Brake Actuator Replacement