Installation Procedure
WARNING: This page is about a different car, the 2021 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
- Position the clutch control module (1) onto the rear axle.
- Reconnect the electrical connector (1 and 2) to the clutch control module.
- Install Wiring Harness Retainer to the Clutch Control Module.
- Install the clutch control module bracket bolts (1). Tighten to 6 N.m (53 lb in).CAUTION:
Refer to Fastener Caution .
- Remove the support and lower the vehicle.
- Reprogram the K47 Rear Differential Clutch Control Module. Control Module References