Installation Procedure
WARNING: This page is about a different car, the 2021 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
- Position the front lower control arm (1) on the vehicle.
- Front Lower Control Arm Rear Bolt (2) - Install [2x]CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.
Install NEW bolts.
- Front Lower Control Arm Rear Nut (1) - Install, but do NOT tighten [2x]
- Front Lower Control Arm Front Bolt (1) - Install and tighten [2x]CAUTION:
Refer to Fastener Caution .
Install NEW bolts.
Tighten
- First Pass: 100 N.m (74 lb ft)
- Final Pass: (90 - 105 degrees)
- Front Lower Control Arm Rear Bolt (2) - Tighten [2x]
Tighten
- First Pass: 100 N.m (74 lb ft)
- Final Pass: (90 - 105 degrees)
- Front Lower Control Arm Ball Stud Nut (1) - Install and tighten
Tighten
- First Pass: 40 N.m (30 lb ft)
- Final Pass: (100 - 115 degrees)
- {If equipped} Front Suspension 4 Corner Leveling System Position Sensor (1) @ Front Lower Control Arm - Install - Front Suspension 4 Corner Leveling System Position Sensor Replacement
- Install the front tire and wheel assembly. Tire and Wheel Removal and Installation
- Measure and adjust the wheel alignment. Wheel Alignment Measurement