Component Testing
WARNING: This page is about a different car, the 2018 GMC Terrain and 2018 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
Windshield Wiper/Washer Switch
- Ignition OFF, disconnect the harness connector at the S82 Windshield Wiper/Washer Switch.
- Test for infinite resistance between the signal terminal 5 and the low reference terminal 1 with the rear window washer switch in the open position.
- If less than infinite resistance
Replace the S82 Windshield Wiper/Washer Switch.
- Go to next step: If infinite resistance
- If less than infinite resistance
- Verify the resistance reading is within the range specified below between the signal circuit terminal 5 and the low reference circuit terminal 1 by cycling the switch between Rear Wiper position and Rear Washers position.
- Rear Wiper : 624-644 Ω
- Rear Wiper Sweep : 1.99-2.01 kΩ
- Rear Washer : 6.11-6.13 kΩ
- If not within range specified
Replace the S82 Windshield Wiper/Washer Switch.
- Go to next step: If within range specified
- All OK