LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2019 >> Sierra 2500 HD Base, 2D Pickup, Gas >> Repair and Diagnosis >> Quick Lookups >> Technical Bulletins >> Campaigns >> Other Variant >> Engine Control Systems >> N202317060 - ECM Reprogramming DATAFILES Incorrect (N202317060)

N202317060 - ECM Reprogramming DATAFILES Incorrect (N202317060)

WARNING: This page is about the Sierra 2500 HD Base, 4D Pickup Crew Cab, 6.0L Eng VIN B, 4WD, Gas/Ethanol, which is a different variant/trim than selected.
Publication date: 2020-12-22
Reference number: N202317060

N202317060 - ECM REPROGRAMMING DATAFILES INCORRECT

N202317060 - ECM REPROGRAMMING DATAFILES INCORRECT

SERVICE CAMPAIGN BULLETIN

Reference Number(s): N202317060, Date of Issue:  Dec 22, 2020
Affected Model(s): 2019 Chevrolet Silverado 2019 GMC Sierra

SERVICE INFORMATION

Release Date:  December 2020 Revision:  00
Make  Model  Model Year  RPO  Description 
From  To 
Chevrolet Silverado 2019 2019 L5P 6.6L, 8 - cylinder, diesel engine
GMC Sierra

Involved vehicles are identified on the Applicable Warranties section in GM Global Warranty Management system. This site should always be checked to confirm vehicle involvement prior to beginning any required inspections and/or repairs.

Condition  General Motors has decided to conduct a Voluntary Emission Recall involving certain 2019 Chevrolet Silverado and GMC Sierra vehicles with a 6.6L diesel engine. The vehicle's Engine Control Module (ECM) may have been reprogrammed during service with incorrect diagnostic software. If that occurred, the ECM may not accurately diagnose a fault in the auxiliary fuel tank system or the four wheel drive system. Further, the ECM may incorrectly report a fault or illuminate the malfunction indicator lamp (check engine light) on vehicles not equipped with these two systems.
Correction  Dealers are to reprogram the ECM.

PARTS INFORMATION

No parts are required for this repair.

WARRANTY INFORMATION

SERVICE INFORMATION

Labor Code  Description  Labor Time  Trans. Type  Net Item 
9105278* Verified Module Software or Calibration Level: Module Is Programmed with Same Level Software or Calibration 0.2 ZFAT N/A
9105279* Engine Control Module Reprogramming with SPS 0.3
IMPORTANT:

*  To avoid warranty transaction rejections, carefully read and follow the instructions below:

  • The Warranty Claim Code must be accurately entered in the "Warranty Claim Code" field of the transaction.
  • When more than one Warranty Claim Code is generated for a programming event, it is required to document all Warranty Claim Codes in the "Correction" field on the job card. Dealers must also enter one of the codes in the "Warranty Claim Code field of the transaction, otherwise the transaction will reject. It is best practice to enter the FINAL code provided by SPS/SPS2.

Warranty Claim Code Information Retrieval 

If the Warranty Claim Code was not recorded on the Job Card, the code can be retrieved in the SPS system as follows:

  1. Open TIS/TLC on the computer used to program the vehicle.
  2. Select and start SPS/SPS2.
  3. Select Settings.
  4. Select the Warranty Claim Code tab.

The VIN, Warranty Claim Code and Date/Time will be listed on a roster of recent programming events. If the code is retrievable, dealers should resubmit the transaction making sure to include the code in the SPS Warranty Claim Code field.

SERVICE PROCEDURE

CAUTION:

Before downloading the update files, be sure the computer is connected to the internet through a network cable (hardwired). DO NOT DOWNLOAD or install the files wirelessly. If there is an interruption during programming, programming failure or control module damage may occur.

NOTE:

Carefully read and follow the instructions below.

  • Ensure the programming tool is equipped with the latest software and is securely connected to the data link connector. If there is an interruption during programming, programming failure or control module damage may occur.
  • Stable battery voltage is critical during programming. Any fluctuation, spiking, over voltage or loss of voltage will interrupt programming. Install a GM Authorized Programming Support Tool to maintain system voltage. Refer to www.gmdesolutions.com  for further information. If not available, connect a fully charged 12 V jumper or booster pack disconnected from the AC voltage supply. DO NOT connect a battery charger.
  • Turn OFF or disable systems that may put a load on the vehicles battery such as; interior lights, exterior lights (including daytime running lights), HVAC, etc.
  • Clear DTCs after programming is complete. Clearing powertrain DTCs will set the Inspection/Maintenance (I/M) system status indicators to NO.
    GM5644477Courtesy of GENERAL MOTORS COMPANY
    GM5431207Courtesy of GENERAL MOTORS COMPANY
IMPORTANT:

Techline Connect and TIS2WEB screens shown above.

IMPORTANT:

If the same calibration/software warning is noted on the TLC or SPS Summary screen, select OK and follow screen instructions. After a successful programming event, the WCC is located in the Service Programming System dialogue box of the SPS Summary screen. No further action is required. Refer to the Warranty section of the bulletin.

IMPORTANT:

When programming a module in GM's new Vehicle Intelligence Platform, or VIP, the power mode (ignition) needs to be off or errors may occur. This involves the 2020 Chevrolet Corvette, Cadillac CT5 and CT4, as well as the upcoming full-size Chevrolet, GMC, Cadillac SUVs and Buick Envision. Serial Data Message Authentication also needs to have the ignition off.

  1. Reprogram the Engine Control Module. Refer to K20 Engine Control Module: Programming and Setup   in SI.
    GM5644478Courtesy of GENERAL MOTORS COMPANY
    GM5431209Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    The screenshots above are an example of module programming and may not be indicative of the specific module that is being programmed. Module selection and VIN information have been blacked out.

    IMPORTANT:

    To avoid warranty transaction rejections, you MUST record the warranty claim code provided on the Warranty Claim Code (WCC) screen shown above on the job card. Refer to callout 1 above for the location of the WCC on the screen.

  2. Record SPS Warranty Claim Code on job card for warranty transaction submission.
  3. CALIFORNIA VEHICLES ONLY: Complete a "Proof of Correction" certificate and provide to the vehicle owner upon recall completion.

DEALER RESPONSIBILITY

All new, used, GM Certified Used, courtesy transportation vehicles, dealer shuttle vehicles, etc. in dealers' possession and subject to this recall must  be held and inspected/repaired per the service procedure of this bulletin before  customers take possession of these vehicles. Involved vehicles must be held and not delivered to customers, dealer-traded, released to auction, used for demonstration, or any other purpose.

All GM Certified Used vehicles currently in the dealers' inventory within the Certified Pre-Owned Inventory System (CPOIS) will be de-certified and must be held and remedied per the service procedure in this bulletin. Upon submitting an accepted/paid warranty transaction in the Global Warranty Management (GWM) system, the vehicle can be re-certified for sale within the CPOIS system, or once again be used in the CTP program.

Dealers are to service all vehicles subject to this recall at no charge to customers, regardless of mileage, age of vehicle, or ownership, from this time forward.

Customers who have recently purchased vehicles sold from your vehicle inventory, and for which there is no customer information indicated on the dealer listing, are to be contacted by the dealer. Arrangements are to be made to make the required correction according to the instructions contained in this bulletin. A copy of the customer letter is provided in this bulletin for your use in contacting customers. Recall follow-up cards should not be used for this purpose, since the customer may not as yet have received the notification letter.

In summary, whenever a vehicle subject to this field action enters your vehicle inventory you must take the steps necessary to ensure the program correction has been made before selling the vehicle. In addition, for vehicles entering your facility for service, you are required to ensure the customer is aware of the open field action and make every reasonable effort to implement the program correction as set forth in this bulletin prior to releasing the vehicle.

***THE FOLLOWING 2 PARAGRAPHS ARE NOT FOR CANADA OR EXPORT***

When a California emissions recall is completed by a GM dealer, the dealer must provide the vehicle owner a "Proof of Correction Certificate" which the owner may need to present to the California Department oof Motor Vehicles (DMV) when renewing their vehicle registration. Without this correction certificate, the owner may be unable to renew their vehicle registration.

Additional Certificates can be obtained, at no charge, from the 1Store application in GlobalConnect. Request GM Item Number 1825 when ordering.

DEALER REPORTS

For dealers with involved vehicles, a listing has been prepared and will be available through GM GlobalConnect Maxis Field Action Reports or sent directly to export dealers. The Inventory tab of the dealer reports will contain VINs that apply to this recall. This information is intended to assist dealers with the PROMPT COMPLETION  of these vehicles. The Customer In-Service tab will contain customer names and addresses from Motor Vehicle Registration Records. The use of such motor vehicle registration data for any purpose other than follow-up necessary to complete this recall may be a violation of law in several states.

COURTESY TRANSPORTATION - FOR USA & CANADA

Courtesy transportation is available for customers whose vehicles are involved in a product program and still within the warranty coverage period. See General Motors Service Policies and Procedures Manual for courtesy transportation program details.

CUSTOMER NOTIFICATION

USA & Canada - General Motors will notify customers of this recall on their vehicle (see copy of customer letter included with this bulletin).

In order to ensure full protection under the emission warranty, and the right to participate in future recalls, the customer notification letter recommends that customers have their vehicles serviced as soon as possible. It also advises that failure to do so could legally be determined to be lack of proper maintenance. The vehicle may fail a state or local emission inspection test if the recall work is not completed.

Export - Letters will be sent to known owners of record located within areas covered by the US National Traffic and Motor Vehicle Safety Act. For owners outside these areas, dealers should notify customers using the attached sample letter.

In order to ensure full protection under the emission warranty, and the right to participate in future recalls, the customer notification letter recommends that customers have their vehicles serviced as soon as possible. It also advises that failure to do so could legally be determined to be lack of proper maintenance. The vehicle may fail a state or local emission inspection test if the recall work is not completed.

OWNER LETTER

January 2020

This notice applies to your vehicle, VIN:  _____________________________________

Dear General Motors Customer:

This notice is sent to inform you that General Motors is conducting a voluntary emission recall that includes your vehicle.

Reason For This Recall:   Your 2019 model year Chevrolet Silverado or GMC Sierra vehicle, equipped with a 6.6 Liter, 8-cylinder diesel engine, may be equipped with an improperly functioning on-board emission-related diagnostic system that violates California and Federal standards and regulations. The vehicle's Engine Control Module (ECM) may have been reprogrammed during service with incorrect diagnostic software. If that occurred, the ECM may not accurately diagnose a fault in the auxiliary fuel tank system or the four wheel drive system. Further, the ECM may incorrectly report a fault or illuminate the malfunction indicator lamp (check engine light) on vehicles not equipped with these two systems

What We Be Done:  Your GM dealer will reprogram the engine control module. This service will be performed for you at no charge  . Eligibility for this service will not be denied solely due to your Chevrolet Silverado or GMC Sierra vehicle having non-GM parts or repairs performed by outlets other than a GM franchised dealer.

How Long Will The Repair Take?   Because of service scheduling requirements, it is likely that your dealer will need your vehicle longer than the actual service correction time of approximately 30 minutes.

What You Should Do:  Please contact your GM dealer as soon as possible to arrange a service date. Instructions for making this correction have been sent to your dealer. Please ask your dealer if you wish to know how much time will be needed to schedule, process, and repair your vehicle.

If you have any questions or need any assistance, just contact your dealer or the appropriate Customer Assistance Center at the number listed below.

Division  Number  Text Telephones (TTY) 
Chevrolet 1-800-630-2438 1-800-833-2438
GMC 1 - 866 - 996 - 9463 1 - 800 - 462 - 8583
Puerto Rico - English 1-800-496-9992  
Puerto Rico - Espa n ol 1-800-496-9993  
Virgin Islands 1-800-496-9994  

Emission Law Information:  In order to ensure your full protection under the emission warranty made applicable to your vehicle by state and federal law, and your right to participate in future recalls, it is recommended that you have your vehicle serviced as soon as possible. Failure to do so could legally be determined to be lack of proper maintenance of your vehicle. Also, your vehicle may fail a state or local emission inspection or I/M smog check test if this recall is not accomplished.

IMPORTANT MESSAGE FOR CALIFORNIA RESIDENTS
The California Air Resources Board (CARB) requires vehicle emission recalls be completed prior to California registration renewal. Uncorrected emission recalls will result in the inability to renew your California vehicle registration.
At the time of emission recall completion, your California dealer will issue a "Proof of Correction Certificate". Keep this certificate and, if required, present it to the Department of Motor Vehicles when renewing your California registration as proof of recall completion.

We are sorry to cause you this inconvenience; however, we have taken this action in the interest of your continued satisfaction with our products.

Maryann L. Combs

Vice President

Global Vehicle Safety

GM Recall: N202317060