Installation Procedure
- Throttle Position Sensor - Install - Throttle Position Sensor Installation
- Throttle Body Gasket (3) - Install NEWNOTE:
Align the tab of the gasket with the notch in the manifold.
- Throttle Body (2) - Install
- Throttle Body Bolt (4) - Install and tighten [2x] 10 N.m (89 lb in)
- Throttle Body Nut (1) - Install and tighten [2x] 10 N.m (89 lb in)
- Connect the electronic throttle control wiring harness connector (3).NOTE:
Verify that the electronic throttle control wiring harness connector seal is properly installed and NOT damaged.
- Air Cleaner Outlet Duct - Install - Air Cleaner Outlet Duct Replacement
- Reprogram the ECM. Service Programming System (SPS)
- Perform the throttle body idle air flow compensation reset. Throttle Body Idle Air Flow Compensation Reset
Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Do not use paints, lubricants, or corrosion inhibitors on fasteners, or fastener joint surfaces, unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems. When using fasteners that are threaded directly into plastic, use extreme care not to strip the mating plastic part(s). Use hand tools only, and do not use any kind of impact or power tools. Fastener should be hand tightened, fully seated, and not stripped.