LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2019 >> Sierra 2500 HD Base, 2D Pickup, Gas >> Repair and Diagnosis >> Engine Mechanical >> Power Takeoff >> Power Take-Off >> Diagnostic Information and Procedures >> DTC P253D >> Circuit/System Testing

Circuit/System Testing

NOTE:

This diagnostic procedure will only diagnose factory installed components. It will not diagnose upfitter provided equipment.

  1. Ignition OFF and all vehicle systems OFF, disconnect the harness connector at the K44 Power Take - Off Control Module. It may take up to 2 min for all vehicle systems to power down.
  2. Test for less than 1 V between the K44 Power Take - Off Control Module status signal connector X2 terminal 8 and ground.
    • If 1 V or greater 

      Repair the short to voltage on the circuit.

    • Go to next step: If less than 1 V 
  3. Test for infinite resistance between the K44 Power Take - Off Control Module status signal connector X2 terminal 8 and ground.
    • If less than infinite resistance 

      Repair the short to ground on the circuit.

    • Go to next step: If less than 2 Ω 
  4. Test for less than 2 Ω end to end between the K44 Power Take - Off Control Module status signal connector X2 terminal 8 and the frame rail X191 Provisional Connector terminal G.
    • If 2 Ω or greater 

      Repair the open/high resistance in the circuit.

    • Go to next step: If less than 2 Ω 
  5. Test or replace the K44 Power Take - Off Control Module.
scientia non olet · About LEMON Manuals