LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2019 >> Sierra 2500 HD Base, 2D Pickup, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different car >> Section 2933 (Hybrid/EV Control System) >> Repair Instructions >> Generator Control Module 3-Phase Cable Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2017 GMC Sierra 1500 and 2017 Chevrolet Silverado 1500. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Starter Generator
    GM4353331Courtesy of GENERAL MOTORS COMPANY
  1. Starter Generator 1 -Remove - Starter Generator Replacement 
    2. Fig 2: Heat Shield Bolt
    GM4371958Courtesy of GENERAL MOTORS COMPANY
  2. Heat Shield Bolt 1 -Remove
  3. Heat Shield 2 -Remove
    4. Fig 3: Cover Bolt
    GM4371972Courtesy of GENERAL MOTORS COMPANY
  4. Cover Bolt 2 -Remove
  5. Cover 1 -Remove
    6. Fig 4: Terminal Cover Seal And Dust Cover
    GM4371975Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Clean and inspect the seal for damage.

  6. Terminal Cover Seal 1 -Remove
  7. Dust Cover 2 -Remove
    8. Fig 5: Generator Control Module 3 Phase Cable Terminal Bolt
    GM4371976Courtesy of GENERAL MOTORS COMPANY
  8. Generator Control Module 3 Phase Cable Terminal Bolt 1 -Remove
    9. Fig 6: Generator Control Module 3--Phase Cable
    GM4371978Courtesy of GENERAL MOTORS COMPANY
  9. Generator Control Module 3 Phase Cable Mounting Bolt 2 -Remove
  10. Generator Control Module 3 Phase Cable 1 -Remove
scientia non olet · About LEMON Manuals