LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Yukon Denali, RWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System >> Repair Instructions >> Rear Wheel Speed Sensor Ring Replacement >> Removal Procedure

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (6-Lug Wheel)Tire and Wheel Removal and Installation (8-Lug Wheel) .
  3. Remove the rear wheel speed sensor. Refer to Rear Wheel Speed Sensor Replacement .
  4. Remove the rear axle shaft bearing. Refer to Rear Axle Shaft Bearing Replacement .
  5. Remove the rear wheel speed sensor ring from the axle housing using the J-45857  tone wheel and/or bearing remover (1) and the J-2619-01  slide hammer (2).
    Fig 1: Removing Wheel Speed Sensor Ring From Axle Housing
    GM889095Courtesy of GENERAL MOTORS COMPANY
scientia non olet · About LEMON Manuals