Antenna Coaxial Cable Replacement - Communication Interface Module to Navigational Signal Splitter

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Antenna Coaxial Cable - Communication Interface Module to Navigational Signal Splitter

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove Instrument Panel Assembly. Refer to Instrument Panel Assembly Replacement (IO5/IO6)Instrument Panel Assembly Replacement (IOB)
1	Antenna Coaxial Cable - Communication Interface Module to Navigational Signal Splitter Procedure Disconnect the electrical connectors. If the antenna cable is taped into the wiring harness, cut the ends off the old antenna and route the new antenna as close to the old one as possible using tie straps to secure the new cable.

Callout

Component Name

Preliminary Procedure
Remove Instrument Panel Assembly. Refer to Instrument Panel Assembly Replacement (IO5/IO6)Instrument Panel Assembly Replacement (IOB)

Antenna Coaxial Cable - Communication Interface Module to Navigational Signal Splitter

Procedure

Disconnect the electrical connectors.
If the antenna cable is taped into the wiring harness, cut the ends off the old antenna and route the new antenna as close to the old one as possible using tie straps to secure the new cable.