LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia SL >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Headlights >> Lighting System >> Diagnostic Information And Procedures >> DTC B2625: Display Dimming Pulse Width Modulation Output Circuit Short To Ground >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connectors at the components listed below.
    • S48B Front Overhead Console Assembly
    • S126 Driver Mode Select Switch
  2. Connect a test lamp between the appropriate control circuit terminal listed below and ground, ignition ON.
    • S48B Front Overhead Console Assembly terminal 18
    • S126 Driver Mode Select Switch terminal 8
  3. Verify the test lamp turns ON and OFF when commanding the Indicator Dimming ON and OFF with a scan tool.
    • If the test lamp is always OFF 
    1. Ignition OFF, disconnect the X1 harness connector at the K9 Body Control Module.
    2. Test for infinite resistance between the control circuit and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • Go to next step : If infinite resistance
    3. Test for less than 2 Ω in the control circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the K9 Body Control Module.
    • If the test lamp is always ON 
    1. Ignition OFF, disconnect the X1 harness connector at the K9 Body Control Module, ignition ON.
    2. Test for less than 1 V between the control circuit terminal and ground.
      • If 1 V or greater, repair the short to voltage on the circuit.
      • If less than 1 V, replace the K9 Body Control Module.
    • Go to next step: If the test lamp turns ON and OFF 
  4. Test or replace the inoperative component.
scientia non olet · About LEMON Manuals