Installation Procedure

Fig 1: Generator Battery Control Wiring Harness Cable

Courtesy of GENERAL MOTORS COMPANY

CAUTION:

Install the generator battery control wiring harness cable (1) to the starter solenoid (3) and tighten the fastener (2) to 9 N.m (80 lb in).

Fig 2: Generator Battery Control Wiring Harness Cable

Courtesy of GENERAL MOTORS COMPANY

Connect the generator battery control wiring harness cable (3) to the generator (4) and tighten the fastener (2) to 15 N.m (11 lb ft).
Install the protective boot (1) over the B + generator stud.

Fig 3: Generator Battery Control Wiring Cable

Courtesy of GENERAL MOTORS COMPANY

Install the generator battery control wiring harness cable (3), to the battery fuse block (4), and tighten the fastener (2) to 9 N.m (80 lb in).
Install the generator battery control wiring harness cable (5) and the battery positive cable (6) to the battery fuse block (4). Tighten the fastener (7) to 9 N.m (80 lb in).
Install the battery fuse block cover (1).
Install the upper intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Dual Battery) Battery Negative Cable Disconnection and Connection (Single Battery) .