Inside Rearview Mirror Replacement

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Inside Rearview Mirror & Fastener

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the windshield multifunction sensor mount bracket cover. Refer to Windshield Multifunction Sensor Mount Bracket Cover Replacement (With UEU, UFL)Windshield Multifunction Sensor Mount Bracket Cover Replacement (Without UEU, UFL)
1	Inside Rearview Mirror Screw CAUTION: Refer to Fastener Caution . Procedure Remove the inside rearview mirror harness cover. Disconnect the electrical connector. Adjust the mirror to the full upward position. Loosen the set screw located at the base of the mirror. Tighten 2 N.m (18 lb in)
2	Inside Rearview Mirror Procedure Slide the mirror upward off of the rearview mirror button.

Callout

Component Name

Preliminary Procedure
Remove the windshield multifunction sensor mount bracket cover. Refer to Windshield Multifunction Sensor Mount Bracket Cover Replacement (With UEU, UFL)Windshield Multifunction Sensor Mount Bracket Cover Replacement (Without UEU, UFL)

Inside Rearview Mirror Screw

CAUTION:

Refer to Fastener Caution .

Procedure

Remove the inside rearview mirror harness cover.
Disconnect the electrical connector.
Adjust the mirror to the full upward position.
Loosen the set screw located at the base of the mirror.

Tighten
2 N.m (18 lb in)

Inside Rearview Mirror
Procedure
Slide the mirror upward off of the rearview mirror button.