Installation Procedure
- Carefully install the battery sensor along with the battery negative cable to the vehicle (1).
- Connect Battery Current Sensor Connector (1).
- Install Battery Negative Cable (3)
- Install Battery Negative Cable Fastener (2) and tighten 13 N.m (115 lb in)
- Close the battery fuse block cover (1).
- Install Battery Negative Cable (1).
- Install Battery Negative Cable Ground Fastener (2) and tighten 22 N.m (16 lb ft)
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Install Battery Negative Cable (1).
- Install Battery Negative Cable Frame Ground Fastener (2) and tighten 22 N.m (16 lb ft)
- Connect the EPS connector (2) to the battery negative cable connector (1) and attach to the front crossmember.
- Battery Negative Cable (2).
- Engine Ground Cable Stud (1) and tighten 58 N.m (43 lb ft)
- Install Underbody Splash Shield. Underbody Splash Shield Replacement
- Lower the vehicle.
- Connect the negative battery cable. Battery Negative Cable Disconnection and Connection
CAUTION:
Refer to Fastener Caution