Installation Procedure

Fig 1: Front Side Door Outside Handle At 90Degrees

Courtesy of GENERAL MOTORS COMPANY

While holding BO-51363 Door Handle Spring Retainer in place, install front side door outside handle (1) into door (2) at approximately a 90 degree angle to door.

Fig 2: Front Side Door Outside Handle & Mechanism

Courtesy of GENERAL MOTORS COMPANY

Rotate front side door outside handle (1) rearward into front side door handle mechanism (2).

Fig 3: Front Side Door Outside Handle

Courtesy of GENERAL MOTORS COMPANY

Fig 4: Front Side Door Outside Handle & Spring Retainer

Courtesy of GENERAL MOTORS COMPANY

Release pressure on BO-51363 Door Handle Spring Retainer. Pull front side door outside handle (1) outward and remove BO-51363 Door Handle Spring Retainer from door (2).

NOTE:

When installing the door lock cylinder screw Do Not go past the hard stop.

Tighten screw for lock cylinder bezel. Refer to Front Side Door Lock Cylinder Bezel Replacement .
Ensure that the door lock system operates properly.