Removal Procedure
- Remove Steering Gear Boot Steering Gear Boot Replacement
- Turn the steering wheel to position the steering gear rack so that only two rack teeth and the flat surface of the rack are visible outside the steering gear housing.
- If equipped with a hydraulic power steering gear, bend the tabs on the steering gear rack thrust washer to release the steering linkage inner tie rod.
- Place a soft jaw pipe wrench or soft jaw pliers on the flat surface of the steering gear rack (3) between the steering gear housing (4) and the steering linkage inner tie rod housing (2).
- Place a crow foot wrench on the flats of the steering linkage inner tie rod housing (2).
- Rotate the steering linkage inner tie rod housing (2) counterclockwise while holding the steering gear rack (3) stationary until the steering linkage inner tie rod (1) separates from the steering gear rack.
- If equipped with a hydraulic power steering gear, remove the steering gear rack thrust washer. DISCARD the washer.
CAUTION:
Do not change the steering gear preload adjustment before moving the inner tie rod from the steering gear. Changing the steering gear preload adjustment before moving the inner tie rod could result in damage to the pinion and the steering gear.