Liftgate Lock Striker Replacement

Fig 1: Liftgate Lock Striker

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the rear end trim finish panel. Refer to Rear End Trim Finish Panel Replacement .
1	Liftgate Lock Striker Bolt (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 25 N.m (18 lb ft)
2	Liftgate Lock Striker Procedure Mark the location of the striker with a grease pencil to ensure proper alignment during installation. Adjust the liftgate if needed.

Callout

Component Name

Preliminary Procedure
Remove the rear end trim finish panel. Refer to Rear End Trim Finish Panel Replacement .

Liftgate Lock Striker Bolt (Qty: 2)

CAUTION:

Tighten
25 N.m (18 lb ft)

Liftgate Lock Striker

Procedure

Mark the location of the striker with a grease pencil to ensure proper alignment during installation.
Adjust the liftgate if needed.