LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2014 >> Terrain SLE, 4D Utility >> Repair and Diagnosis >> External Pages >> Different car >> Section 199 (Object Detection System - Park Assist System) >> Diagnostic Information and Procedures >> Front View Camera Module Malfunction (UFL) >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2012 GMC Terrain and 2012 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.

Lane Departure Warning Switch Malfunction

  1. Ignition OFF, remove the ignition key, open the driver door and disconnect the scan tool, all vehicle systems OFF, this may take up to 2 min.
  2. Disconnect the harness connector at the S70L Steering Wheel Controls Switch - Left.
  3. Test for less than 5 Ω between the S70L Steering Wheel Controls Switch - Left ground circuit terminal 7 and ground.
    • If greater than the specified value, test the ground circuit for an open/high resistance.
  4. Ignition ON, verify the scan tool Lane Departure Warning Switch Status parameter is OPEN.
    • If not the specified value, test the signal circuit terminal 2 for a short to ground. If the circuit tests normal, replace the K109 Front View Camera Module.
  5. Install a 3 A fused jumper wire between the signal circuit terminal 2 and ground circuit terminal 7. Verify within 10 s the scan tool Lane Departure Warning Switch Status parameter is CLOSED.
    • If not the specified value, test the signal circuit terminal for a short to battery or an open/high resistance. If the circuit tests normal, replace the K109 Front View Camera Module.
  6. If all circuits test normal, replace the S70L Steering Wheel Controls Switch - Left.

Lane Departure Warning Switch Indicator Malfunction

  1. Ignition OFF, remove the ignition key, open the driver door and disconnect the scan tool, all vehicle systems OFF, this may take up to 2 min.
  2. Disconnect the harness connector at the S70L Steering Wheel Controls Switch - Left.
  3. Test for 6.2-10.9 V DC between the S70L Steering Wheel Controls Switch - Left BCM pwm reference circuit terminal 4 and ground.
    • If not the specified value, test the circuit for a short to ground or short to voltage.
  4. Disconnect the harness connector at the K109 Front View Camera Module, reconnect the harness connector at the S70L Steering Wheel Controls Switch - Left.
  5. Ignition ON, observe the lane departure warning switch indicator. The indicator should be OFF.
    • If the indicator is always ON, test the control circuit terminal 5 for a short to ground. If the circuit tests normal, replace the S70L Steering Wheel Controls Switch - Left.
  6. Ignition OFF, install a 3 A fused jumper wire between the K109 Front View Camera Module harness connector indicator control circuit terminal 4 and ground. The indicator should be ON.
    • If the indicator is always OFF, test the control circuit terminal 4 for an open/high resistance. If the circuit tests normal, replace the S70L Steering Wheel Controls Switch - Left.
  7. If all circuits test normal, replace the K109 Front View Camera Module.
scientia non olet · About LEMON Manuals