Circuit/System Testing
WARNING: This page is about a different car, the 2012 GMC Terrain and 2012 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF and all vehicle systems OFF, disconnect the harness connector at the K109 Front View Camera Module and at the S70L Steering Wheel Controls Switch - Left. It may take up to 2 minutes for all vehicle systems to power down.
- Test for infinite resistance between the S70L Steering Wheel Controls Switch - Left control circuit terminal 5 and ground.
- If less than infinite resistance
Repair the short to ground on the circuit.
- If infinite resistance
- If less than infinite resistance
- Ignition ON.
- Test for less than 1 V between the S70L Steering Wheel Controls Switch - Left control circuit terminal 5 and ground.
- If greater than 1 V
Repair the short to voltage on the circuit.
- If less than 1 V
- If greater than 1 V
- Ignition OFF.
- Test for less than 2 Ω in the S70L Steering Wheel Controls Switch - Left control circuit terminal 5 end to end.
- If 2 Ω or greater
Repair the open/high resistance in the circuit.
- If less than 2 Ω
- If 2 Ω or greater
- Test for infinite resistance between the S70L Steering Wheel Controls Switch - Left control circuit terminal 4 and ground.
- If less than infinite resistance
Repair the short to ground on the circuit.
- If infinite resistance
- If less than infinite resistance
- Ignition ON.
- Test for less than 1 V between the S70L Steering Wheel Controls Switch - Left control circuit terminal 4 and ground.
- If greater than 1 V
Repair the short to voltage on the circuit.
- If less than 1 V
- If greater than 1 V
- Ignition OFF.
- Test for less than 2 Ω in the S70L Steering Wheel Controls Switch - Left control circuit terminal 4 end to end.
- If 2 Ω or greater
Repair the open/high resistance in the circuit.
- If less than 2 Ω
- If 2 Ω or greater
- Replace the S70L Steering Wheel Controls Switch - Left, ignition ON.
- Verify the DTC does not set while operating the vehicle under Conditions for Running the DTC.
- If the DTC sets
Replace the K109 Front View Camera Module.
- If the DTC does not set
- If the DTC sets
- All OK.