Navigation Signal Splitter Replacement

WARNING: This page is about a different car, the 2010 GMC Terrain and 2010 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Navigation Signal Splitter

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the driver side knee bolster reinforcement. Refer to Driver Knee Bolster Reinforcement Replacement (Equinox) or Driver Knee Bolster Reinforcement Replacement (Terrain)
1	Navigation Signal Splitter Bolt (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten: 9 N.m (80 lb in)
2	Navigation Signal Splitter Procedure Disconnect the electrical connections. For programming and set up procedures, refer to Control Module References

Callout

Component Name

Preliminary Procedure:
Remove the driver side knee bolster reinforcement. Refer to Driver Knee Bolster Reinforcement Replacement (Equinox) or Driver Knee Bolster Reinforcement Replacement (Terrain)

Navigation Signal Splitter Bolt (Qty: 2)

CAUTION: Refer to Fastener Caution .

Tighten: 9 N.m (80 lb in)

Navigation Signal Splitter

Procedure

Disconnect the electrical connections.
For programming and set up procedures, refer to Control Module References