Engine Speed Power Take-Off Control Module Replacement

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 GMC Sierra 3500 HD, 2013 GMC Sierra 2500 HD, 2013 GMC Sierra 1500, 2013 Chevrolet Silverado 3500 HD, and 2013 Chevrolet Silverado 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Engine Speed Power Take-Off Control Module

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Disconnect the harness conector.
1	Power Take Off (PTO) Module Bolt (Qty: 3) CAUTION: Refer to Fastener Caution . Procedure Loosen the three PTO module fasteners (1). Lift the module (2) up and off the bracket. Bolt heads should pass through the holes in the bracket. Position the PTO module so that the fasteners engage the narrow slots in the bracket before tightening the outer fasteners. TIP: It is not necessary to fully remove the PTO module fasteners from the module except when transferring the fasteners to a new module. Tighten 9 N.m (80 lb in)
2	PTO Module Procedure Disconnect the electrical connector from the PTO module. New PTO module must be programed. Refer to Control Module References .

Callout

Component Name

Preliminary Procedure
Disconnect the harness conector.

Power Take Off (PTO) Module Bolt (Qty: 3)

CAUTION:

Refer to Fastener Caution .

Procedure

Loosen the three PTO module fasteners (1).
Lift the module (2) up and off the bracket.
Bolt heads should pass through the holes in the bracket.
Position the PTO module so that the fasteners engage the narrow slots in the bracket before tightening the outer fasteners.

TIP: It is not necessary to fully remove the PTO module fasteners from the module except when transferring the fasteners to a new module.
Tighten
9 N.m (80 lb in)

PTO Module

Procedure

Disconnect the electrical connector from the PTO module.
New PTO module must be programed. Refer to Control Module References .