Electronic Brake Control Module Programming and Setup: Notes

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 GMC Sierra 3500 HD, 2013 GMC Sierra 2500 HD, 2013 GMC Sierra 1500, 2013 Chevrolet Silverado 3500 HD, and 2013 Chevrolet Silverado 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

DO NOT program a control module unless directed to by a service procedure or a service bulletin. If the ECU is not properly configured with the correct calibration software, the ECU will not control all of the vehicle features properly.
Ensure the programming tool is equipped with the latest software and is securely connected to the data link connector. If there is an interruption during programming, programming failure or ECU damage may occur.
Turn OFF or disable systems that may put a load on the vehicles battery such as; interior lights, exterior lights (including daytime running lights), HVAC, radio, etc.
During the programming procedure, follow the SPS prompts for the correct ignition switch position.
Clear DTCs after programming is complete. Clearing powertrain DTCs will set the Inspection/Maintenance (I/M) system status indicators to NO.