LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2014 >> Sierra 2500 HD SLT, 6.6L Eng VIN 8, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2503 (Programming And Setup - All Systems) >> Repair Instructions >> Body Control Module Programming and Setup >> Programming the BCM

Programming the BCM

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 GMC Sierra 3500 HD, 2013 GMC Sierra 2500 HD, 2013 GMC Sierra 1500, 2013 Chevrolet Silverado 3500 HD, and 2013 Chevrolet Silverado 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

After the procedure is completed, the personalization settings of the BCM are set to default settings. Inform the customer that the personalization must be set again.

To program and setup an existing or new replacement Body Control Module, perform the following procedure:

  1. Access the Service Programming System (SPS) and follow the on-screen instructions. Refer to Service Programming System (SPS) .
  2. On the SPS Supported Controllers screen, select BCM Body Control Module - Programming and Setup and follow the on-screen instructions.
NOTE:

After programming, perform the following to avoid future misdiagnosis:

  1. Turn the ignition OFF for 10 seconds.
  2. Connect the scan tool to the data link connector.
  3. Turn the ignition ON, with the engine OFF.
  4. Use the scan tool in order to retrieve history DTCs from all control modules.
  5. Clear all history DTCs.
scientia non olet · About LEMON Manuals