LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2013 >> Sierra 1500 XFE >> Repair and Diagnosis >> External Pages >> Different car >> Section 2956 (Object Detection System And Pedestrian Protection System) >> Diagnostic Information and Procedures >> DTC P15F6: Front Object Detection Control Module Torque Request Signal Message Counter >> Diagnostic Aid

Diagnostic Aid

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2017 GMC Sierra 3500 HD, 2017 GMC Sierra 2500 HD, 2017 GMC Sierra 1500, 2017 Chevrolet Silverado 3500 HD, and 2017 Chevrolet Silverado 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

This is an informational DTC set by the engine control module. It is set to provide an indication that the Frontview Camera Module will not be able to perform as intended. Diagnose any other DTCs first. During normal diagnostic and/or repair verification technicians may find that a "Service Driver Assist System" message may be displayed by the Frontview Camera Module. Do not replace the Frontview Camera Module for this condition.

If the Service Driver Assist System message is displayed with no DTCs set, perform the following steps:

  1. Remove the key from the ignition, open and close the driver's door to turn off retained accessory power, and wait 60 s.
  2. Ignition ON, if the Service Driver Assist message is still present, operate the vehicle at speeds greater than 15 km/h (10 mph) to complete the self test. The Frontview Camera Module should request the message to turn off.
  3. If the telltales remain on with no DTCs set after the drive cycle, disconnect the battery for at least 60 s, then reconnect the battery.
  4. Operate the vehicle at speeds greater than 40 km/h (25 mph), the Frontview Camera Module should request all indicators to turn off.
scientia non olet · About LEMON Manuals