LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2013 >> Sierra 1500 XFE >> Repair and Diagnosis >> External Pages >> Different car >> Section 2956 (Object Detection System And Pedestrian Protection System) >> Diagnostic Information and Procedures >> DTC B127B: Rearview Camera Input Signal (with IO3) >> Circuit/System Verification

Circuit/System Verification

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2017 GMC Sierra 3500 HD, 2017 GMC Sierra 2500 HD, 2017 GMC Sierra 1500, 2017 Chevrolet Silverado 3500 HD, and 2017 Chevrolet Silverado 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

If the condition is intermittent or cannot be duplicated, disconnect the connectors and add Nyogel lubricant 760G. This procedure will correct the high resistance condition due to terminal fretting corrosion.

  1. Verify P17 Info Display Module displays infotainment system information properly.
    • If infotainment system information displays properly 
  2. Verify there is no debris on the B87 Rearview Camera lens and that the bezel and bezel seal are not damaged.
    • If debris is found on the lens 

      Clean the lens. If the lens, bezel, or bezel seal are damaged, replace as necessary.

    • If there is no debris on the lens 
  3. Engine running, transmission in R.
  4. Verify the backup lamps are illuminated.
    • If the backup lamps are illuminated 
  5. Engine running, transmission in R.
  6. Verify a clear rear vision image is displayed on the P17 Info Display Module.
    • If a clear image is not displayed 

      Refer to Circuit/System Testing.

    • If a clear image is displayed 
  7. All OK.