LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2011 >> Terrain SLT, 2.4 C, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 178 (Lighting System) >> Diagnostic Information and Procedures >> DTC B3650 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2010 GMC Terrain and 2010 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the X1 harness connector at the S78 Turn Signal/Multi-Function Switch.
  2. Ignition OFF and all vehicle systems OFF. It may take up to 2 minutes for all vehicle systems to power down. Test for less than 5 Ω between the ground circuit terminal 6 and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify the scan tool High Beam Select Switch parameter is Inactive.
    • If not the specified value, test the signal circuit terminal 11 for a short to ground. If the circuit tests normal, replace the K9 BCM.
  4. Install a 3 A fused jumper wire between the signal circuit terminal 11 and the ground circuit terminal 6. Verify the scan tool High Beam Select Switch parameter is Active.
    • If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the K9 BCM.
  5. If all circuits test normal, test or replace the S78 Turn Signal/Multi-Function Switch.
scientia non olet · About LEMON Manuals