LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2011 >> Canyon 4D Pickup, 3.7 E, RWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 3.7L - Repair Instructions >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: View Of CKP Sensor Wiring Harness Connector, Engine Wiring Ground Leads & Engine Oil Pan Rail Retainers
    GM1350744Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the engine wiring harness electrical connector (3) from the crankshaft position (CKP) sensor (1).
    3. Fig 2: View Of Crankshaft Position Sensor
    GM858202Courtesy of GENERAL MOTORS CORP.
  3. Remove the CKP sensor bolt.
  4. Remove the CKP sensor from the engine block.

    Discard the O-ring seals.

scientia non olet · About LEMON Manuals