LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2009 >> Yukon Hybrid, 4WD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Hybrid Engine Controls - Introduction >> Repair Instructions >> Drive Motor Generator Control Module Sight Shield Replacement >> Installation

Drive Motor Generator Control Module Sight Shield Replacement: Installation

    Fig 1: View Of Sight Shield & Fasteners
    GM1971274Courtesy of GENERAL MOTORS CORP.
    NOTE: The sight shield mounting fastener must be installed and tightened. Failure to properly tighten the sight shield mounting fastener may result in an open High Voltage Interlock Circuit (HVIC) condition and DTCs.
  1. Install the sight shield onto the ball studs (2) and tighten the sight shield mounting fastener (1). Tighten the fastener to 5 N.m (44 lb in).
  2. Install the fender brace. Refer to Front Fender Rear Upper Bracket Replacement .
  3. Enable high voltage. Refer to High Voltage Enabling .
scientia non olet · About LEMON Manuals