LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2009 >> Envoy 4.2 S, RWD >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Steering Gear Replacement >> Removal Procedure

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Install a drain pan under the vehicle.
  3. Remove the tires and wheels. Refer to Tire and Wheel Removal and Installation .
    4. Fig 1: View Of Tie Rod Retaining Nut
    GM687432Courtesy of GENERAL MOTORS CORP.
  4. Remove and discard the outer tie rod retaining nuts.
    5. Fig 2: Removing Outer Tie Rod Assembly From Steering Knuckle
    GM643351Courtesy of GENERAL MOTORS CORP.
    CAUTION: Do not attempt to disconnect a steering linkage joint by driving a wedge between the joint and the attached part. Seal damage may result which will cause premature failure of the joint.
  5. Disconnect the outer tie rods from the steering knuckles using J 24319-B  . See Special Tools .
  6. Remove the steering gear crossmember. Refer to Front Steering Gear Crossmember Replacement .
  7. Disconnect the lower intermediate shaft from the power steering gear. Refer to Lower Intermediate Steering Shaft Replacement .
    8. Fig 3: View Of Power Steering Gear Retaining Bolt
    GM687443Courtesy of GENERAL MOTORS CORP.
  8. Remove the power steering hose assembly to the power steering gear retaining bolt.
  9. Remove the power steering hose assembly from the power steering gear.
  10. Support the power steering gear.
    11. Fig 4: View Of Power Steering Gear & Bolts
    GM687447Courtesy of GENERAL MOTORS CORP.
  11. Remove the power steering gear mounting bolts.
  12. Remove the power steering gear from the vehicle.
  13. Remove the outer tie rods from the inner tie rods. Refer to Steering Linkage Outer Tie Rod Replacement .
scientia non olet · About LEMON Manuals