Installation Procedure

WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Axle Lower Control Arm To Frame Mounting Nut & Bolt

Courtesy of GENERAL MOTORS CORP.

Install the lower control arm.
Install the rear axle lower control arm to the frame mounting nut and bolt.

Fig 2: View Of Rear Axle Lower Control Arm To Axle Mounting Nut & Bolt

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the rear axle lower control arm to the axle mounting bolt and nut.
Tighten: Tighten the lower control arm mounting bolts to 100 N.m (74 lb ft).
Remove the rear axle support.
Lower the vehicle.