LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2009 >> Canyon 4D Pickup, 2.9 9 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 2.9L - Introduction, Service & Repair >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Fuel Tank Module
    GM1766555Courtesy of GENERAL MOTORS CORP.
  1. Lightly lubricate the sensor seal with clean engine oil.
  2. Press the sensor fully into the fuel tank module.
  3. Connect the chassis wiring harness electrical connector to the pressure sensor (1).
  4. Install the left pickup box wheelhouse liner. Refer to Pickup Box Wheelhouse Liner Replacement .
  5. If the vehicle is a crew cab, install the fuel tank. Refer to Fuel Tank Replacement .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals