LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2008 >> Yukon Hybrid, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 175 (Cruise Control System) >> Diagnostic Information and Procedures >> DTC B0835 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2009 GMC Yukon XL, 2009 GMC Yukon, 2009 Chevrolet Tahoe, 2009 Chevrolet Suburban, and 2009 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the steering wheel controls switch - left.
  2. Ignition ON, verify that a test lamp illuminates between the signal circuit terminal 9 and B+.
    • If the test lamp does not illuminate, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the BCM.
  3. If all circuits test normal, test or replace the steering wheel controls switch - left.
scientia non olet · About LEMON Manuals