LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2008 >> Acadia SLT, FWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Starter Motor Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Identifying Starter Heat Shield Bolt & Shield
    GM1861146Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the left catalytic convertor. Refer to Catalytic Converter Replacement - Left Side .
  3. Remove the starter heat shield bolt and shield.
    4. Fig 2: View Of Battery Positive Junction Block Cable Clip & Terminal
    GM1861148Courtesy of GENERAL MOTORS CORP.
  4. Remove the starter solenoid BAT terminal nut (3).
  5. Remove the battery positive junction block cable terminal (2) from the starter.
    6. Fig 3: Identifying Engine Wiring Harness Electrical Connector
    GM1860484Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the engine wiring harness electrical connector (1) from the starter.
    7. Fig 4: View Of Starter Bolts
    GM1861149Courtesy of GENERAL MOTORS CORP.
  7. Remove the starter bolts and starter.
scientia non olet · About LEMON Manuals