Circuit/System Verification
- Inspect the rearview camera for any debris on the lens or a damage bezel or bezel seal.
- Clean any debris from the lens. If the lens, bezel, or bezel seal are damaged, replace as necessary
- Ignition ON, vehicle in PARK, verify the backup lamps are off.
- If the backup lamps are illuminated, refer to Rear Vision System Always On .
- Command the backup lamps ON with a scan tool, a clear rear view image should be displayed on the radio
- If a clear image is not displayed, refer to Sear Vision System Does Not Display
- If the Service Rear Vision Camera System message is displayed, refer to Service Rear Vision Camera System is Displayed .