Removal Procedure
WARNING: This page is about a different car, the 2006 GMC Sierra and 2006 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Open the side access door.
- Remove the side access door trim, if equipped. Refer to Trim Panel Replacement - Side Access Door .
- If the original reveal molding on the window is damaged it must be replaced, if equipped.
- Leave a base of urethane on the pinchweld flange.
- The only suitable lubrication is clear water.
- Use J 24402-A , J 39032 or equivalent in order to remove the window. See Special Tools .
- With the aid of an assistant, remove the window from the opening.
CAUTION:
If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or personal injury.
IMPORTANT:
Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
CAUTION:
When working with any type of glass or sheet metal with exposed or rough edges, wear approved safety glasses and gloves in order to reduce the chance of personal injury.
IMPORTANT:
Keep the cutting edge of the tool against the window.
This will allow the urethane adhesive to be separated from the window.
This will allow the urethane adhesive to be separated from the window.