LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2007 >> Sierra Classic 1500 HD, 4WD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Generator Cable Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Battery Cables At Junction Block
    GM662521Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the generator cable (2) to the junction block.
  2. Install the generator cable nut.

    Tighten:  Tighten the nut to 9 N.m (80 lb in).

  3. Close the positive cable junction block.
    4. Fig 2: View Of Generator Cable & Nut
    GM395686Courtesy of GENERAL MOTORS CORP.
  4. Install the generator cable to the generator, perform the following:
    1. Install the generator cable to the stud.
    2. Install the generator cable nut.

      Tighten:  Tighten the nut to 9 N.m (80 lb in).

    3. Position the boot to cover the stud.
  5. If necessary, install the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement (4.8L, 5.3L, and 6.0L - RPO LQ4) or Upper Intake Manifold Sight Shield Replacement (6.0L - RPO LQ9) .
  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Auxiliary Battery)  or Battery Negative Cable Disconnection and Connection (Single Battery) .
scientia non olet · About LEMON Manuals