LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2007 >> Sierra Classic 1500 HD, 4WD >> Repair and Diagnosis >> Brakes >> Anti-Lock Brake System & Traction Control System >> Repair Instructions >> Electronic Brake Control Module Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing EBCM (w/JL4)
    GM925878Courtesy of GENERAL MOTORS CORP.
    IMPORTANT:
    • Do not reuse the old mounting screws. Always install new mounting screws with the new EBCM.
    • Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
  1. Install the EBCM to the BPMV.
    2. NOTE: Refer to Fastener Notice .
    Fig 2: Exploded View Of EBCM & BPMV Components (w/JL4)
    GM925574Courtesy of GENERAL MOTORS CORP.
  2. Install the new EBCM screws (1).

    Tighten:  Tighten the screws to 5 N.m (39 lb in) in an X-pattern.

  3. Lower the vehicle.
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Auxiliary Battery) or Battery Negative Cable Disconnection and Connection (Single Battery) .
  5. If installing a replacement module, program the replacement module. Refer to Control Module References .
  6. Turn the ignition to the ON position. DO NOT start the engine.
  7. Perform the Diagnostic System Check - Vehicle .
scientia non olet · About LEMON Manuals